Share Reach over Wi-Fi
Some devices cannot run Reach and never will — a smart TV, a games console, a printer, a robot vacuum. They have a Wi-Fi chip and no way to install anything.
So instead of putting Reach on the device, you make the device join Reach: your Windows machine becomes a Wi-Fi network, and everything that joins it goes out the same way your own traffic does.
Set it up
-
Tray icon → tick "Share Reach over Wi-Fi."
It turns on app routing first if it isn't already, and says so — the network it shares is the Reach adapter, so there's nothing to share without it. Expect a Windows administrator prompt the first time; that installs the piece that owns the network adapter.
-
Tick "Route everything through Reach."
Do this. A TV has no idea what a split tunnel is: it expects to be in another country, not to have three domains proxied. Without this, on a machine with no routing rules, your guest devices leave from your own address and nothing is achieved.
This affects your machine too — all your own traffic goes through Reach while it's on. That's why it's a separate switch and not automatic. See Proxy modes: Rules, Direct, Global for what "everything" means next to your existing per-app rules.
-
Choose where guests should appear from.
The panel always tells you, in the row that starts "Guests appear from…":
- a Reach gateway (pick the country in Gateway — see Gateway regions), or
- someone who has shared their connection with you (Appear from).
Read that row before you hand the password out. It's the only thing on screen that tells you whose address your TV is about to use.
-
Join the device. Click "Show QR code to join" and point the device's camera at it, or type the network name and password shown in the panel.
That's it. The panel then shows how many devices have joined, out of the maximum Windows allows.
What to expect
Up to 8 devices. That ceiling is Windows', not ours — its Mobile Hotspot caps at 8
and we read the number from Windows rather than guessing. The panel shows 3 of 8 devices so you know whether one more will fit.
Realistically 2–3 of them streaming. Everything shares one connection through one tunnel. 4K is roughly 15–25 Mbps per stream, so bandwidth runs out long before the device count does.
Guests spend your allowance. Their traffic is your traffic as far as metering is concerned. A film in 4K is several gigabytes. See Managing your data.
Guests inherit your exit. If you're appearing from a friend's connection, so is the TV — and that friend's allowance is involved too. Handing out the Wi-Fi password is closer to lending your identity than lending bandwidth. Only give it to people you would lend it to.
If something doesn't work
"Sharing over Wi-Fi needs app routing, and it could not be started." App routing didn't come up — usually a declined administrator prompt. Try the toggle again and accept it.
The panel says "Sharing is ON but NOT going through Reach." The access point is up but we can't confirm it's carrying traffic through Reach — most likely because something else (Windows Settings) started a hotspot first. Turn sharing off and on again, which stops and restarts it on the Reach adapter. If it persists, get in touch; that one is a bug.
A device joins but has no internet. Check the "Guests appear from…" row. If it says "no destinations route through Reach yet," turn on Route everything through Reach (step 2 above).
Streaming says you're in the wrong country. Check that row again — it's the source of truth. If it names the right place and the service still disagrees, the service may be refusing that address specifically; try a different gateway, or an exit node, which uses an ordinary home connection rather than a data centre.
You need more than 8 devices, or you want this without leaving a PC on. That's a router's job, not a laptop's. Get in touch.